Category

How to use a jewelry rotary tumbler for polishing jewelry?

Do as much hand-finishing as possible. The tumbler will polish the surface but if there’s a scratch it will still be there (and maybe even more visible!) when you pull it out. When I hand-finish I sand up to 1200 or 1500 grit and then use a white polishing pad before tumbling.

Do NOT set your stone. Tumbling is probably okay for some harder stones, but it can harm softer stones – especially turquoise, pearl, amber, malachite, etc. And if you have a hard stone and a soft stone in the same tumbling session, the hard stone might affect the softer one. I know a lot of people who tumble their piece after setting the stone and they feel that it’s safe. Personally, I prefer not to risk it. So, experiment if you want to but be aware that some stones may dull in the jewelry rotary tumbler.

65W Jewelry Polisher Tumbler 5Kg Capacity Mini Rotary Tumbler Machine with Timer Jewelry Polisher Finisher for Jewelry Stone

Optional: Oxidize your piece and wipe off the surface patina with a white polishing pad. Tumbling will clean up your metal and some of the patina will be removed (especially if you leave it in for a long time), but most of the time the patina stays in the recessed areas and looks great!
Put your steel shot and your jewelry in the drum. Fill it with water just about an inch above the contents.

KT-130 Jewelry Magnetic Polishing Tumbler Jewelry Polisher Finishing Machine Jewelry Surface Polishing Grinding Cleaning

Add a burnishing lubricant. In this case, I mean Dawn dish soap.  A small squirt will work. The instructions of jewelry magnetic tumbler that come with the tumbler say “no more than two drops” but I’ve used more with no problems. Too much and it’s just way too sudsy. I’ve also heard Simple Green works well. Stay away from abrasive or citrus cleaners as they might eat away at the rubber drum.

Close up the drum, set it on the rollers and plug in. Leave it to tumble for at least 30 minutes. Two hours is usually good. You can tumble as long as you want but there is a point where you may be removing fine details so be sure to check it now and then.

When it’s done, pour everything into a strainer over the sink. Rinse it well. Pour it out onto a tray lined with paper towels and pull out your pieces. Be sure to allow the shot to dry thoroughly before storing it away.


Previous:Basic Knowledge of Jewelry Engraving You Should Know
Next:How To Choose A Proper Gem Faceting Machine
No reviews
Write a review Your Name:


Your Email:


Your Review:
Rating: